Observer guide
Good data comes from doing the same simple things the same way every day. These are the standards Blue Hill Observatory, CoCoRaHS and the National Weather Service Cooperative Observer Program all use.
1 · Your observation day
- Pick one time and stick to it. 7 AM is standard (it matches CoCoRaHS and most NWS Co-op stations). Some long-time Blue Hill observers used 9 PM — that's fine, just be consistent.
- Each report covers the 24 hours ending at your observation time and is dated the day you take it. Rain that fell Tuesday afternoon goes on Wednesday morning's report.
- Zeros count. "0.00 — nothing fell" is real data. Blank means "didn't measure".
- Away for a few days? When you get back, report the total and choose Covers: N days.
- Use T (trace) for a few drops or flakes too small to measure (under 0.01″ of rain, under 0.1″ of snow).
2 · Rain and melted precipitation
- Use a 4-inch clear plastic gauge (about $40 — the CoCoRaHS gauge) or an NWS 8-inch gauge. Small hardware-store wedge gauges under-catch in wind.
- Mount it 2–5 ft up on a post, top level, in the open: at least twice as far from any tree or building as that obstacle is tall. Not on a roof or fence rail next to a house.
- Read the inner tube to the hundredth (0.01″). If it overflowed, pour the inner tube out, then measure the outer cylinder in the tube and add it up.
- In winter, take the funnel and inner tube off so snow collects in the outer cylinder. Bring it inside, melt it, and report the water as precipitation.
3 · Snow
Following the NWS Snow Measurement Guidelines:
- New snowfall — measure on a snow board (a white-painted 2×2 ft piece of plywood) set on top of the old snow, in an open spot away from drifts. Measure to the tenth of an inch. Include sleet.
- Measure as soon as the snow stops, or at your observation time. Clear the board only once per observation day (or no more than every 6 hours during a storm, and then add the readings up). Clearing more often inflates totals.
- Snow depth — the total snow and ice on the ground. Average several readings with a ruler or stake and round to the whole inch. Report it every day there's snow on the ground, including 0 the day it melts.
- Snow water equivalent (SWE) — optional but valuable: push your gauge's outer cylinder down through the snow (a "core"), melt it and measure the water.
- Snow-to-liquid check: typical New England snow is 8–15″ of snow per 1″ of water. If your ratio is wildly off, measure again.
4 · Temperature
- The sensor must be in a ventilated radiation shield (louvered, white) — never in direct sun.
- About 5 ft above grass, ideally 30+ ft from pavement, walls, AC units and dryer vents. Rooftops and decks read warm.
- Report the high and low for your 24-hour day, plus the temperature at observation time, then reset your max/min thermometer.
5 · Sunshine, wind and the rest
- Sunshine — Blue Hill has recorded hours of sunshine since the 1880s. If you have a sunshine recorder, report hours of bright sunshine. If your station has a solar-radiation sensor, we estimate sunshine from the time it reads above 120 W/m² — that's marked "estimated", since the true WMO definition uses direct-beam sunlight.
- Wind — report the day's peak gust and its direction. Anemometers need to be well above the roof (ideally 33 ft) to be representative.
- Weather that occurred — tick fog (visibility under ½ mile), thunder (heard), hail, sleet, glaze (freezing rain coating), etc. These feed the "days with…" rows on your annual summary, just like the old paper form.
6 · Storm reports
- File a storm report for nor'easters, heavy downpours (more than about 1″ in a few hours), ice, hail, damaging wind or flooding. Interim totals during the storm are welcome.
- Hail: measure the largest stone with a ruler if you can (pea 0.25″, penny 0.75″, quarter 1″, golf ball 1.75″). Don't use "marble".
- Wind: say whether the gust was measured or estimated.
- Safety first. This network does not issue warnings. For dangerous weather, call 911 and report it to your local NWS office or through mPING.
7 · Connect an automated station
Register your station first; its page shows your Station ID and upload key. Automated readings fill in your daily high, low, rain, gust and sunshine estimate. Snow still needs a person with a ruler, so manual reports are always welcome alongside.
Ecowitt (GW1000/GW2000/HP2551 and similar)
- WS View Plus or Ecowitt app → your gateway → Weather Services → Customized.
- Enable it. Protocol: Wunderground. Server: skylog.bluehill.org. Port: 443 (or 80). Upload interval: 60–300 seconds.
- Station ID = your station code (e.g. BH-MA-0012). Station key = your upload key. Path: /ingest.php?
Ambient Weather (WS-2902, WS-5000…)
- awnet app → your console → Customized server. Protocol: Wunderground (or Ambient).
- Server skylog.bluehill.org, port 80, path /ingest.php?ID=YOURCODE&PASSWORD=YOURKEY&
Davis (Vantage Pro2, Vue, WeatherLink Live / Console)
Generate a v2 API key at WeatherLink.com → Account, then paste the key and secret into your station settings. We read your current conditions every 15 minutes. (Davis's free plan shares only current conditions, which is all we need.)
WeeWX, Cumulus MX, Meteobridge, Weather Display
Add a second "Weather Underground" uploader pointed at https://skylog.bluehill.org/ingest.php with your station code as the ID and your upload key as the password. All of them use the standard WU parameters (tempf, dailyrainin, windgustmph, solarradiation…).
Tempest
Tempest doesn't support custom upload servers yet. Use WeeWX with the WeatherFlow driver, or keep filing manual reports — we're working on a direct connection.
8 · Your data
- It's yours, and it's open. Download your full record anytime. The whole network is free through the open data API — no paywall.
- Your exact location is rounded to about ½ mile on public pages unless you choose otherwise. Your email is never shown.
- Every report passes automatic checks (high below low, impossible amounts, odd snow ratios). We'll ask you to double-check anything unusual; staff may mark clear errors so they don't skew maps and totals.
- Siting classes (1 = textbook, 5 = poor/unknown) let researchers choose which stations to use. Every class is useful.
